Not a Member? Signup LOGIN:        
AD CATEGORY :: Hot Rod/Street Rod/Custom :: Chevy Small Block 1980-1997
Ad #1155148   
This ad expires in 18 days.
Recommend AdContact SellerAdd To Favorites

81 Camaro Z-28 Blown Stroker

Resto Rod w/ Attitude

View Extra Large Photos
$15,000.00
Would really like to sell asap. Retiring end of 08 and moving South mid 09, requires downsizing of toy closet. Listed price is very negotiable, no (reasonable) offer refused. May be able to deliver part way. Will be shown @ the 'Right Coast' Car Show @ NYS Fairgrounds Syracuse, NY in July 08.

- Engine built Sept. 1999. Body totally dismantled and repainted Spring 2003.
- Only 12000 +/- miles since engine build.
- New 'GM' 350 4 bolt block (now 383).
- 'TRW' pistons: 7.5 c.r.w/ 76cc heads.
- 'AFR' alum. heads, 76 cc, angle plug, 2.02 int./ 1.60 exh.
- 'Herbert' & 'Crane', roller rockers, 280/290 dur., 112 deg. lobe cntr.
- 'Cola' 5140 steel crank for GM 400 blk.
- 'GM' 400 blk. rods, ground & shot peened.
- 'Performance Dist.' HEI distributer w/ 'MSD-6AL' ignition sys. w/ rev. limiter module.
- 'Dyers' 6V71 blower on 'Dyers' custom low profile manifold, 3" belt drive, 15% underdrive, 6-8# boost, dual 'Holley' 650 cfm #1850 carbs.
- 'Mallory' 110 elec.fuel pump @ tank.
- 'Hooker ' hdrs, 'Flowmaster' exhaust.
- 'Fluid-Damper' Comp. balancer w/ 2nd spline added.
- 'Muncie m-21', close ratio 4 spd. w/ new 'Hurst' shifter.
- Rebuilt stock 'GM' posi-tration rear end w/ 3.73 gears.
- 'Centerforce' comp. dual plate clutch.
- 'Competition Eng.' sub frame connectors
- 'South Side Mach.' traction bars.
- 'Vette Brakes' transverse fiberglass frnt. leaf spring suspension w/ H.D. rear disc brake kit & new leaf springs, vented rotors, H.D. 1" anti-sway bar, 'KYB' shocks all around.
- 4 tube radiator w/ pusher & puller fans


- Body completely stock except for 'Harwood' hood scoop & no decals.
- All body weatherstriping, dr. hinges, dr. glass, dr. latch/locks have been replaced.
- No heater, A.C., radio.
- No rust EVER, Stored inside Nov.to April.
- Never been raced or dyno'd. Engine built by local drag racer and his estimated HP is between 500 & 600. From his test drives should do 1/4 in low 12's or better. My personal experience = really really fast w/ tons of torque. Can take off in 2nd w/o a problem.
- Minor blemishes from from normal driving over last 5 years but not noticeable unless pointed out. Car is show-able as is without embarrassment and gets EVERYBODY'S attention when you start it up.

This item is USED

Trades NOT ACCEPTED

Payment options:

Cash

Item Location: CAMILLUS, NY Get Directions

Send Message To Seller
This ad expires in 18 days.




Is this classified ad inappropriate?
Report it here


RaceSpace Profile
Seller Information

Ad posted by: certifiable (#190618)
RaceSpace Profile: View
Member Since: 2007-04-30
Number of Honor Payments: 0
Average Accepted Sale Price: $0.00
Average Honor Payment: $0.00
Phone Number: work 3154555941
Phone Number: home 3154885708
Contact Seller
Report A Sale
Member OTHER ADS
  • Member has no other classified ads.

Questions & Answers about this ad

Question:

What is the total miles on your car?.We are looking at a couple of cars but this one is really nice.Thankyou Jack

Answer:

On [2008-03-23 01:02:51] BADDOG509 wrote: > What is the total miles on your car?.We are looking at a couple of cars but this one is really nice.Thankyou Jack I think there are about 86,000 miles on the car, however,there is very little left of the original car other than the boy and the interior. Almost all of the running gear has been replaced and or rebuilt since 99 when the engine was built and has had only 12,000 since then. From memory, I think that the transmission and the rearend were rebuilt sometime between 1990 and 1995. The car was originally purchased by my son and some of the details i'm a little unsure of. He purchase it in the spring of 99 and from then until his death in 04 we both worked on it extensively.

Questions & Answers about this ad

Question:

Do you have any pics. of the chassic , we have to rely on pics. because we live in WA.state. Could you send me the pics. to jnlbarbee@hughes.net. Thank You Jack

Answer:

On [2008-03-23 13:57:24] BADDOG509 wrote: > Do you have any pics. of the chassic , we have to rely on pics. because we live in WA.state. Could you send me the pics. to jnlbarbee@hughes.net. Thank You Jack Sorry, Im pretty sure that I don't have any pictures of the chassis. I will look around an see if there are any other photos that my son took while we were working on the car, but I'm not very hopefull. If you'd like I can give you the phone # of the mechanic that built the engine and I know he's more that a little familiar with it as he has done all the routine mainteance on it since it was built. Let me know?

Questions & Answers about this ad

Question:

What is the best cash price you would take for the camaro? How far could you meet? I am in Alabama

Answer:

On [2008-08-10 15:20:54] alabamawalker wrote: > What is the best cash price you would take for the camaro? > > How far could you meet? > > I am in Alabama Best price $13,500 + plane ticket home. With $1,000 nonrefundable deposit I will meet you half way +/- @ a major city airport with flight connections to Syracuse, NY.





Home | Classifieds | About | Contact | Store | Advertise | Affiliate Program | Pricing Guide | FAQ | Send Link to a Friend
Raceway Media, LLC
PO Box 491, North Adams, MA 01247
Tel: 413.663.3496 • Fax: 413.663.3615 • Email: support@racingjunk.com
HACKER SAFE certified sites prevent over 99.9% of hacker crime.

Execution Time: 561 ms

Buy, Sell and Trade Race Cars for Free