406 Small Block Chevy and Dedenbear Glide

406 s/b Chevy and Dedenbear case glide/converter complete.

406 s/b injected on alcohol complete Hat to pan. 740 hp, 650 ft/lbs, have dyno sheet. Hard parts: GM Sportsman Bowtie block 4-bolt mains front to rear center three are splayed, has priority oiling, Lunati Pro-Series 4340 crank and Pro-Mod 6� rods, Clevite bearings, JE Pistons, 13.75:1 final comp, Total Seal Gapless rings, tool steel pins, Stef�s Aluminum step pan w/ trap door and windage screen, Mellings HV/HP oil pump, Lunati roller � small cam - have specs, Brodix Track 1 heads, T&D shaft rocker system, K-Motion valve springs, Titanium retainers, Heads have been ported and flow 305cfm, Stall header adapter plates still on heads, MSD crank-trigger, distributor and wires, Fluidampr damper, Meziere water pump, Moroso 4-Vane Vacuum pump, Enderle Hat on Edelbrock Tunnel Ram, Enderle 80-A pump, Kinsler hi-speed bypass, includes: all fuel lines, 5-gal fuel cell and Holley "black" primer pump.

$10,500.00 obo.


Transmission: Dedenbear case glide, 1.76 Coan Superset planetary, Coan brake and 5200 converter, pg spline, best parts, comes with Mark Williams yoke. Deep cast alum pan, tapped for temp sending unit. Have spare 5200 converter � pg spline.

$2,800.00 obo.


The above drivetrain ran very consistent 5.50s-5.60s in 2325lb car and is very reliable. 6800 shift rpm, 6500 thru traps 1/8 mile, 7500 rpm 1/4 mile. 4.57 geared car w/ 33� tall rubber. Both engine and trans have been well maintained since being built.

This item is USED

Trades NOT ACCEPTED

Payment options:

cash

Item Location: TERRE HAUTE, IN Get Directions

Instructions for buyer:  If paying by Money Order or Cashiers Check, will hold items until check clears.
Buyer to pick up engine. Will not ship.
Will ship transmission. Buyer to pay for all shipping and handling charges.

This ad expired 19 days ago.