79 Hurst Olds hot rod project for sale cheap

have a 79 hurst, settup for street/strip. 30x13.50 ET streets in back, car has weld pro stars all the way around. Holley blue pump/regulator, electric fan, auto meter water and temp guages, hooker 3203 headers for 455 and 3 1/2 flomaster exhaust dumped before the rearend. Stock 7.5" rear with adjustable upppers on the car. I have the double adjustable lowers i'll throw in the trunk. Dynamic mechanical diode sprag torque convertor(4000-4500 stall but streetable), th400 trans with b&m shift kit. 6" cowl scoop from VFN. Car is in gray primer right now, was originally black and gold. Stock black interior with his/hers shifter.

I have a 455 block that needs to be overbored(rust is creeping on it), and another in storage that is a fresh .060 overbore but that block has 2 sleeves. Several sets of heads for bb and sb olds, including a pairof C heads and a pair of 5's. Cylinder heads i had for this engine are G castings with 2.125/1.687 valves with heavy porting, needs a pushrod sleeve and some epoxy on one of the intake ports where i spent a little more time on them after disassembling the engine the last time after losing a cam lobe. Bullet flat tappet springs and retainers, 10 degree locks. Heads are disassembled now.Have a crank that needs turning as well. No intake or oil pans, they are sold now.

Also have all the parts to a 69 350 gas engine that is disassembled, (where the 5 heads are from), and some headers for a 455 in a trans am. Have a set of Gil boat headers with 2 1/4" primary tubes and 5" bell collectors, one of them is cut about 5 to 6 inches from the flange as i was going to use these to make custom headers for a project. Have a th350 that was rebuilt in mid 90's with a stock convertor for bop pattern as well.

I've sold most of the perormance crap over the 2 years the car has been off the street, but have a few non egr cast iron intakes. Several sets of pistons and rods for bb and sb, to much crap to even think of to list. Throw in my cherry picker (orange from harbor freight used very little with no rust) and a timing light or two and other tuning crap like vacuum guages, etc. Need cash now, lost my job over a month ago,pick up all of this in Wichita Falls Texas area for 1600.

Email me at loftinrandy@yahoo. com or PM me here on the message board, or call (940)-692-5022. Not sure if i'll be around to answer the phone except hours between 6 and 10 pm central time.

This item is USED

Trades NOT ACCEPTED

Item Location: WICHITA FALLS, TX Get Directions

This ad expired 36 days ago.